FHEHS 900 B2
■ 10 │ GB
♦ Sawing off larger branches
♦ When sawing larger branches (Ø 8–25 cm), first make a relief cut
A
(see figure).
■ A relief cut also prevents peeling of the bark on the main trunk.
♦ Saw from the top
B
to the bottom
A
.
2
1
Saw in sections
Long or thick branches should be shortened before making the final cut
(see figure).
cb a
Working safely
■ Keep the appliance, the cutting mechanism and the blade guard in
good condition to prevent injury.
■ If the appliance has been dropped, check for significant damage or
defects.
■ Maintain the specified angle 60°±10° to ensure safe operation (see
figure).
■ Do not use the appliance while standing on a ladder or with unsteady
footing.
■ Do not be tempted into making a poorly considered cut. You could
endanger yourself and others.
■ Children should be supervised to ensure that they do not play with the
appliance.
■ Change your working position regularly. Using the appliance for a long
time can lead to vibration-related circulation disorders of the hands.
You can extend the usage duration by using appropriate gloves or by
taking regular breaks. Note that any personal predisposition to poor
blood circulation, low external temperatures or large gripping forces
can reduce the usage period.
■ You can reduce the vibration risk, for example, the risk of Raynaud’s
phenomenon, by taking regular breaks during which you rub your
hands together.
Transport
■ Use the protective cases
for transporting the appliance.
■ Ensure that the appliance cannot switch on during transport (see
figure).
Maintenance and cleaning
WARNING! If the mains cable needs to be replaced,
this must be carried out by the manufacturer or an
authorised representative in order to avoid safety
hazards.
■ The motor unit must always be kept clean, dry and free from oil or
grease.
■ The pole pruner must be cleaned of sawdust at regular intervals.
♦ Use a soft, dry cloth to clean the housing.
♦ Remove the sprocket cover
.
♦ Remove the saw chain
from the blade and clean the guide
rail
.
♦ Keep the saw chain
sharp and check the tension; check the oil level
and the oil supply.
♦ Check the hedge trimmer for loose screws on the cutter bar
and
tighten these if necessary.
♦ Remove stuck cuttings.
♦ Maintain the cutter bar
using an oil spray or an oil can.
Storage
■ Always clean the appliance thoroughly before storing.
■ Store the appliance in the supplied protective cases in a dry
place and out of the reach of children.
■ Store the appliance horizontally or secured against falling.
■ Empty the oil tank
. Organic chain oil can resinify or leak through
the vent hole in the oil filler cap
.
A
B
C A B
max. 60°±10°
To Next Page
Loading...
