Need help?Do you have a question about the Flowserve Logix 510si and is the answer not in the manual?
General| Manufacturer | Flowserve |
|---|---|
| Model | Logix 510si |
| Category | Controller |
| Input Signal | 4-20 mA |
| Supply Voltage | 24 VDC |
| Operating Temperature | -40 to 85°C (-40 to 185°F) |
| Enclosure | NEMA 4X, IP66 |
| Type | Digital Position Controller |
| Communication Protocol | HART |
Definitions of safety terms like DANGER, WARNING, CAUTION, and NOTE used in instructions.
Step-by-step guide for initiating and performing a quick calibration sequence.
Instructions for calibrating the 4-20 mA input or output current loop using the Loop Calibration button.
Detailed steps for calibrating the 4-20 mA input signal for the positioner.
Detailed steps for calibrating the 4-20 mA output signal for the positioner.
To Next Page