Fluance Ai81 - Volume Adjustment; Adjusting Source LED Brightness; Troubleshooting

Fluance Ai81 User Manual 14
Troubleshooting
No Power
• Ensure the LED Brightness is not set to OFF
• Check all connections on power adapter and ensure fully inserted
No Audio
• Check volume on Ai81 and ensure it is above 0
• Check volume on source device and ensure it is above 0
• Conrm Ai81 is set to correct source
• Ensure all cables are connected properly and fully inserted
No Audio from Passive Speaker
• Check speaker wire connections between speakers and ensure securely
connected to binding posts
Poor Audio
• Ensure the colored wires are connected to the corresponding colored
binding posts on each speaker
• Test with another audio source device to determine source of issue
• Adjust bass and treble settings on both Ai81 and the source device. The source device
equalizer may need to be disabled or set to at (0) to prevent audio distortion.
• Volume normalization should also be disabled on the source device for best performance.
Hissing Noise
• Ensure the colored wires are connected to the corresponding colored
binding posts on each speaker
• Test using different RCA or Aux cables
• If using with a turntable, ensure the ground cable is connected properly
No Sound from Subwoofer
• Conrm the subwoofer is connected to power and is turned on
• Ensure the subwoofer cable is fully connected and secure
• Adjust the volume on the subwoofer and set the crossover to 80 Hz