18
STEP 13: FINE-TUNE BOWL WATER LEVEL
A: FILL BOWL WITH A GALLON OF WATER
Wait 1 minute until the bowl water level recedes
down and stops.
B: MARK THE WATER LEVEL IN THE BOWL
With a pencil, draw a line at the top of the water level
in bowl. (Pencil mark will easily wash o).
C: FLUSH TOILET TO CHECK BOWL
WATER LEVEL
If the water level matches the line you’ve made in
the bowl when the ll valve stops lling the tank,
the water level is correct, proceed to Step 13.
TOO HIGH
TOO LOW
If the water level matches the line in the bowl and the
ll valve is STILL FILLING, then the bowl water is
TOO HIGH, proceed to Step 12D.
If the valve shuts o and the water level does NOT
match the line in the bowl, the water level is TOO
LOW, proceed to Step 12D.
E: FLUSH TOILET,
CHECK BOWL WATER LEVEL
Repeat Steps 12D and 12E until water level in bowl
matches the line when the ll valve shuts o.
D: ADJUST THE BOWL WATER LEVEL
TOO HIGH:
Turn the dial clockwise.
TOO LOW:
Turn the dial counter-clockwise.
LESS WATER
MORE WATER
To Next Page
Loading...
Need help?
General
