AUTOMATIC UNIT CONVERSION E110-SERIES TUTORIAL
Page 2 FW_E110_AutoUnitConv_002_EN
Disclaimer
This E110-series tutorial is created to provide as accurate and authoritative information
regarding the subjects covered as was available at the time of writing. The copyright owner
of this E110-series tutorial cannot take any responsibility or liability for any errors or
omissions in this E110-series tutorial or for discrepancies arising from the features of any
actual item in the respective refit being different from those shown in this E110-series
tutorial. The publisher and copyright owner shall not be liable under any circumstances, for
any consequential, special, contingent, or incidental damages or injury, financial or
otherwise, suffered by any part arising out of, connected with, or resulting from the use of
this E110-series tutorial or the information contained therein.
Copyright
© 2016 Fluidwell BV - All rights reserved
Nothing from this E110-series tutorial may be reproduced, or transmitted in any form or by
any means, electronic or mechanical, including photocopying, recording or any information
storage or retrieval system without prior written approval by Fluidwell BV.
Trademarks
All trademarks used in this E110-series tutorial are the property of their respective owners.
Document control
This E110-series tutorial is an addendum to the documentation set that came with the E-
series. It is the responsibility of the owner to keep the documentation set up-to-date.
We reserve the right to make changes of any kind without prior written notice. Please visit
our internet site for the latest information and (product) updates.
This E110-series tutorial is a translation of: FW_E110_AutoUnitConv_001_EN.
Revision history
K-Factor calculation revised
To Next Page
Loading...
Need help?
General
