Fluke Calibration 5560A User Manual

120 pages

To Next Page

5560A/5550A/5540A

Calibrator

Remote Programmers Manual

April 2022

All product names are trademarks of their respective companies.

Table of Contents3
Introduction5
Contact Fluke Calibration5
Remote Operations6
Set up the IEEE-488 Port for Remote Control7
IEEE-488 Interface Configuration7
IEEE-488 Bus Communication Overview8
USBTMC Interface8
Set up the USBTMC Port for Remote Control8
USBTMC Communication Overview9
Use USBTMC to Communicate with the Product9
RS-232 Serial Interface10
Use the RS-232 Port for Remote Control10
RS-232 Interface Specifications10
Set up the RS-232 Port for Remote Control10
RS-232 Port Setup Procedure10
Exceptions for Serial and Ethernet Remote Control11
Ethernet Interface11
Set up and Connect the Ethernet Interface11
Set the IP Address11
Select the Dynamic Host Configuration Protocol (DHCP)12
Set a Static Internet Address12
Configure the General Network Socket Port12
Configure the LAN Default Gateway13
Set the LAN Subnet Mask13
Read the MAC Address13
Establish an Ethernet Connection13
Terminate an Ethernet Connection14
Ethernet Remote Control14
Change between Remote and Local Operation14
Local State14
Local with Lockout State14
Remote State14
Remote with Lockout State15
RS-232 Interface Overview16
RS-232/IEEE-488 Cables and Connectors17
IEEE-488 Connector17
RS-232 Serial Connector18
IEEE-488 Interface Overview19
USBTMC Interface Overview22
How to Use Commands22
Types of Commands23
Device-Dependent Commands23
Common Commands23
Query Commands23
Interface Messages (IEEE-488)23
Compound Commands25
Coupled Commands26
Overlapped Commands26
Sequential Commands27
Commands that Require You to Unsecure the Calibrator27
Commands for RS-232/Ethernet Only27
Commands for IEEE-488 Only28
Command Syntax29
Parameter Syntax Rules29
Extra Space or Tab Characters30
Terminators31
Incoming Character Processing31
Response Message Syntax32
Check Product Status33
Status Byte Register (STB)33
Service Request (SRQ) Line35
Service Request Enable Register (SRE)36
Program the STB and SRE36
Event Status Register (ESR)36
Event Status Enable (ESE) Register36
Bit Assignments for the ESR and ESE37
Program the ESR and ESE37
Instrument Status Register (ISR)38
Instrument Status Change Registers38
Instrument Status Change Enable Registers38
Bit Assignments for the ISR, ISCR, and ISCE39
Program the ISR, ISCR, and ISCE40
Output Queue40
Error Queue41
Remote Program Examples41
Guidelines for Programming the Calibrator41
Writing an SRQ and Error Handler42
Verify a Meter in the IEEE-488 Bus43
OPC?, *OPC, and *WAI44
Take a Thermocouple Measurement45
Input Buffer Operation45
Remote Commands46
Command Summary by Function46
Commands56
Error Codes115

Need help?

Do you have a question about the Fluke Calibration 5560A and is the answer not in the manual?

Fluke Calibration 5560A Specifications

General

Brand	Fluke Calibration
Model	5560A
Category	Test Equipment
Language	English

Related product manuals

Fluke Calibration 5730A

260 pages

Fluke Calibration 9500B

150 pages

Fluke Calibration 5560A User Manual

Table of Contents

Fluke Calibration 5560A Specifications

Related product manuals