To Next PageTo Next Page
Need help?Do you have a question about the Fluke Calibration 5730A and is the answer not in the manual?
General| Brand | Fluke Calibration |
|---|---|
| Model | 5730A |
| Category | Test Equipment |
| Language | English |
Identifies dangerous conditions and procedures for safe operation.
Details electrical specifications for DC and AC voltage, current, resistance.
Provides steps for inspecting the calibrator upon arrival.
Details instructions for placing the calibrator on a bench or in a rack.
Explains automatic detection of line voltage and acceptable ranges.
Details controls, displays, indicators, and terminals on the front panel.
Details terminals, sockets, and connectors on the rear panel.
Explains how to power on the calibrator and the power-up process.
Explains the difference between OPERATE and STANDBY modes.
Instructions on connecting the calibrator to the Unit Under Test.
Guides on setting output amplitude, frequency, and function.
Details the IEEE-488 interface for remote control.
Describes the RS-232 serial interface for remote control.
Explains how to set up and connect the Ethernet interface.
Details how to use the USB port for remote control.
Explains syntax rules for remote commands.
Explains the calibration procedure for the 5730A Calibrator.
Details the artifact calibration process using external standards.
Provides procedures for calibrating to external standards and checking calibration.
