Fluke Calibration 5560A - Table of Contents

i
Table of Contents
Title Page
Introduction................................................................................................ 1
Contact Fluke Calibration .......................................................................... 1
Remote Operations ................................................................................... 2
Set up the IEEE-488 Port for Remote Control........................................... 3
IEEE-488 Interface Configuration ......................................................... 3
IEEE-488 Bus Communication Overview ............................................. 4
USBTMC Interface .................................................................................... 4
Set Up the USBTMC Port for Remote Control...................................... 4
USBTMC Communication Overview..................................................... 5
Use USBTMC to Communicate with the Product ................................. 5
RS-232 Serial Interface ............................................................................. 6
Use the RS-232 Port for Remote Control ............................................. 6
RS-232 Interface Specifications ........................................................... 6
Set up the RS-232 Port for Remote Control.............................................. 6
RS-232 Port Setup Procedure .............................................................. 6
Exceptions for Serial and Ethernet Remote Control ............................. 7
Ethernet Interface...................................................................................... 7
Set up and Connect the Ethernet Interface .......................................... 7
Set the IP Address................................................................................ 7
Select the Dynamic Host Configuration Protocol (DHCP) .................... 8
Set a Static Internet Address ................................................................ 8
Configure the General Network Socket Port......................................... 8
Configure the LAN Default Gateway..................................................... 9
Set the LAN Subnet Mask ......................................................................... 9
Read the MAC Address ........................................................................ 9
Establish an Ethernet Connection ........................................................ 9
Terminate an Ethernet Connection....................................................... 10
Ethernet Remote Control ...................................................................... 10
Change Between Remote and Local Operation ................................... 10
Local State............................................................................................ 10
Local with Lockout State....................................................................... 10
Remote State........................................................................................ 10
Remote with Lockout State................................................................... 11
RS-232 Interface Overview ....................................................................... 12
RS-232/IEEE-488 Cables and Connectors ............................................... 13