Fluke Calibration 8588A - Page 28

8588A/8558A
Remote Programmer's Manual
24
Table 6. Command Summary (cont.)
Keyword Description
[:SENSe]:CURRent:AC
COUNTer:BLIMit[:STATe] <boolean> Turn the frequency path bandwidth limit ON or OFF
COUNTer:BLIMit[:STATe]?
Return the state of the frequency path bandwidth limit setting.
Returns 1 for Auto range ON, 0 for auto range OFF
:COUNter:COUPling AC|DC
Set the frequency path coupling to ac or dc. Note: if signal path
coupling is ac, frequency path coupling is forced to ac
:COUNter:COUPling? Return the frequency path coupling setting
:COUNter:GATE:AUTO[:STATe]
<boolean>
Turn Auto selection of counter gate ON or OFF
:COUNter:GATE:AUTO[:STATe]?
Return the state of the counter gate auto setting, 1 for Auto gate
ON, 0 for auto gate OFF
:COUPling:AC|DC
Set the ac current signal path coupling to ac or dc. Note: if
signal path coupling is ac, frequency path coupling is forced to
ac
:COUPling? Return the frequency path coupling setting
:FILTer <nrf>|MIN|MAX|DEF Set filter value or min, max or default filter
:FILTer? [MIN|MAX|DEF] Return the filter setting
:RANGe:AUTO[:STATe] <boolean> Turns Auto range ON or OFF
:RANGe:AUTO[:STATe]? Returns 1 for Auto range ON, 0 for auto range OFF
:RANGe <nrf>|MIN|MAX|DEF Set maximum expected value or min, max or default range
:RANGe? [MIN|MAX|DEF]
Returns the selected range or, or if specified, the minimum,
maximum or default range
:RESolution <nrf>|MIN|MAX|DEF
Set maximum expected value or min, max or default resolution;
for example, range is 1 A, Resolution <nrf>. = 0.0001 (100 µA),
the measurement is returned with a resolution of +1.000E-4
:RESolution? [MIN|MAX|DEF]
Returns the selected resolution, or if specified, the minimum,
maximum or default range
:SECondary OFF|FREQuency|
PERiod|PTP|PPEak|NPEak|CFACtor
Sets the secondary reading type