Reference Multimeter and 8 ½ Digit Multimeter
SCPI Commands Reference
31
Table 6. Command Summary (cont.)
Keyword Description
:THReshold <nrf>|MIN|MAX|DEF
Set Threshold to the numeric value or to the MIN, MAX, or
Default threshold setting
:THReshold? [MIN|MAX|DEF]
Return the Threshold numeric value or if specified, the MIN,
MAX, or Default threshold setting
[:SENSe]:POWer
:AVERage <nrf>|AUTO Set the number of readings to average
:AVERage? Return the number of readings being averaged
:FREQuency <nrf> Frequency at which to measure power
:FREQuency? Returns the set power frequency
:IDENtity? Returns the identity of the RF sensor
:RELative RELative | ABSolute Selects Relative (True) or Absolute (False) measurements
:RELative? Returns Relative (=1) or False (=0)
:RELative:REFerence <value>|LReading
Sets the reference value or the last reading as reference for
relative measurements
:RELative:REFerence? Returns the reference level
:UNITs DBM|WATTs|VRMS|VPPK|DBUV
:UNITs? Returns the selected units
[:SENSe]:RESistance
:APERture <seconds>|MIN|MAX|DEF
Sets the ADC aperture value in seconds or to the MIN, MAX or
default setting
:APERture? [MIN|MAX|DEF]
Returns the aperture setting or the MIN, MAX or Default settings
in seconds
:APERture:MODE AUTO|FAST|MANual Sets the aperture mode
:APERture:MODE? Returns the aperture mode
:NPLC <plcs>MIN|MAX|DEF
Sets the ADC aperture in number of power line cycles or to the
MIN, MAX or default plc setting
:NPLC? [MIN|MAX|DEF]
Returns the ADC aperture in number of power line cycles or to
the MIN, MAX or default plc setting
:MODE NORMal|HIV Sets the 2-wire Ohms mode
:MODE? Returns the 2-wire Ohms mode setting
:LOWI [:STATe]<boolean> Sets the Low current mode ON or OFF
:LOWI[:STATe]? Returns the low current mode setting
To Next Page
Loading...