Fluke Calibration 8588A - SCPI device specific errors - (-399, -300)

8588A/8558A
Remote Programmer's Manual
70
SCPI device specific errors - (-399, -300)
-300, "Device-specific error;GPIB Controller not found",
-300, "Device-specific error;GPIB Primary address not
accepted",
-300, "Device-specific error;Bad GPIB controller read
operation",
-300, "Device-specific error;Bad GPIB controller send
operation",
-300, "Device-specific error;GPIB DOS Error",
-300, "Device-specific error;Specified GPIB Interface Board
is not active controller",
-300, "Device-specific error;GPIB interface Board has not
been addressed properly",
-300, "Device-specific error;GPIB invalid argument",
-300, "Device-specific error;GPIB specified GPIB Interface
Board is not System Controller",
-300, "Device-specific error;GPIB I/O operation aborted
(time-out)",
-300, "Device-specific error;GPIB non-existent GPIB board",
-300, "Device-specific error;GPIB routine not allowed
during asynchronous I/O operation",
-300, "Device-specific error;GPIB no capability for
operation",
-300, "Device-specific error;GPIB file System Error",
-300, "Device-specific error;GPIB command byte transfer
error",
-300, "Device-specific error;GPIB serial poll status byte
lost",
-300, "Device-specific error;GPIB SRQ stuck in ON
position",
-300, "Device-specific error;GPIB table problem",
-300, "Device-specific error;Range or function zero
operation failed",
-300, "Device-specific error;Zeroing of input failed",
-300, "Device-specific error;Calibration data corrupt",