Fluke 115C - Safety Symbols and Compliance; Understanding Safety Symbols; Safety Compliance Standards

True-rms Multimeters
Safety Information
3
• Comply with local and national safety requirements when working in hazardous locations.
• Use proper protective equipment, as required by local or national authorities when working
in hazardous areas.
• Avoid working alone.
• Use only the replacement fuse specified or the protection may be impaired.
• Check the test leads for continuity before use. Do not use if the readings are high or noisy.
• Do not use the Auto Volts function to measure voltages in circuits that could be damaged by
this function’s low input impedance (≈3 kΩ)(117 only).
Symbols
B AC (Alternating Current) I Fuse
F DC (Direct Current) T Double Insulated
X Hazardous voltage W Important Information; Refer to manual
N
Battery (Low battery when shown on the
display.)
J Earth ground
~
Do not dispose of this product as unsorted
municipal waste. Contact Fluke or a
qualified recycler for disposal.
D AC and DC