Need help?Do you have a question about the Fluke 115C and is the answer not in the manual?
General| Continuity | Yes |
|---|---|
| Diode Test | Yes |
| Safety Rating | CAT III 600 V |
| Display | LCD |
| DC Voltage Range | 600 V |
| AC Voltage Range | 600 V |
| DC Current Range | 10 A |
| AC Current Range | 10 A |
| Resistance Range | 40 MΩ |
| Capacitance Range | 1000 μF |
| Temperature Range | -40 to 400 °C |
| Battery Life | 200 hours |
| AC Bandwidth | 500 Hz |
| Battery Type | 9 V |
| Accuracy | 0.5% + 2 |
Overview of the Fluke 115C and 117C true-rms multimeters.
Explains voltage alerts and test lead safety precautions.
Defines symbols for AC, DC, hazardous voltage, battery, and disposal.
Lists compliance with relevant safety standards and regulations.
Identifies and explains the various symbols and indicators on the meter's display.
How to use Display HOLD and backlight functions.
Describes the meter's manual and autoranging capabilities.
Details the function of each terminal for measurements.
Explains common error codes and their meanings.
Explains the automatic sleep mode to conserve battery power.
How to capture and analyze minimum, maximum, and average readings.
How to freeze the display for easier reading.
How to turn the display backlight on and off.
Describes the meter's manual and autoranging capabilities.
Steps for measuring resistance accurately.
How to check for opens and shorts using the continuity function.
Guide for measuring AC and DC voltages.
How to measure small AC and DC voltage values.
Using the Auto Volts function for simplified voltage measurements.
Procedure for measuring AC and DC current.
How to measure signal frequency using the meter.
Using VoltAlert for non-contact AC voltage detection.
Methods for measuring high currents using optional probes.
Guide for measuring capacitance values.
Explains the bar graph feature for analog-like readings.
How to detect AC voltage using the meter's proximity sensor.
Performing capacitance measurements in low impedance mode.
Step-by-step guide for testing diodes with the multimeter.
Procedure for testing the multimeter's fuse.
Instructions for replacing the battery and fuse in the multimeter.
How to clean the multimeter's case and terminals.
To Next Page
