Fluke 113 User Manual

Model 113 English Instruction Sheet
Page 1
®
113
Electrical Multimeter
Instruction Sheet
Safety Information
A Warning statement identifies hazardous conditions and actions
that could cause bodily harm or death.
A Caution statement identifies conditions and actions that could
damage the Meter or the equipment under test.
To avoid possible electric shock or personal injury,
follow these guidelines:
• Use the Meter only as specified in this instruction sheet
or the protection provided by the Meter might be
impaired.
• Do not use the Meter or test leads if they appear
damaged, or if the Meter is not operating properly.
• Always use proper terminals, switch position, and range
for measurements.
• Verify the Meter's operation by measuring a known
voltage. If in doubt, have the Meter serviced.
• Do not apply more than the rated voltage, as marked on
Meter, between terminals or between any terminal and
earth ground.
• Use caution with voltages above 30 V ac rms, 42 V ac
peak, or 60 V dc. These voltages pose a shock hazard.
• Disconnect circuit power and discharge all high-voltage
capacitors before testing resistance, continuity, diodes,
or capacitance.
PN 3083192 December 2007, Rev. 1, 12/08
©2007, 2008 Fluke Corporation. All rights reserved.
Specifications subject to change without notice. Printed in China

Fluke 113 Specifications

General

Backlight	Yes
Product type	Digital multimeter
Frequency range	0.5 - 1 kHz
AC voltage range	2000 - 0.001 V
DC voltage range	6000 - 0.001 V
Capacitance range	1000 - 1 nF
Resistance resolution	0.1 Ω
Resolution (DC voltage)	0.1 mV
Basic accuracy (DC current)	2.0% + 3
Basic accuracy (capacitance)	1.9% + 2 100 μF - 1000 μF: 1.9% + 2 1000 μF: 5% + 20
Temperature measurement range	-10 - 50 °C
Dimensions (WxDxH)	167.1 x 85.1 x 46 mm
Battery voltage	9 V

Weight and Dimensions

Weight	404 g