Earth Ground Clamp
Maintenance
15
Maintenance
XW Warning
To prevent a possible electrical shock, fire, or personal injury:
•
Do not operate the Product with covers removed or the case open. Hazardous
voltage exposure is possible.
•
Repair the Product before use if the battery leaks.
•
Use only specified replacement parts.
•
Have an approved technician repair the Product.
•
Remove the input signals before you clean the Product.
•
Do not use the HOLD function to measure unknown potentials. When HOLD is
turned on, the display does not change when a different potential is measured.
Clamp Care
W Caution
To avoid damaging the Clamp, do not use aromatic hydrocarbons or chlorinated solvents
for cleaning. These solutions will react with the plastics used in the Clamp.
Clean the case with a damp cloth and weak detergent. Do not use a solvent or cleaners with abrasives.
Battery Replacement
XW Warning
To prevent false readings that could lead to possible electric shock or
personal injury, replace the batteries as soon as the low battery indicator
() appears.
To replace the battery:
1. Push and hold N >2 s to turn off the Clamp.
2. See Table 7 for details on how to replace the battery.
Replacement Parts
Replacement parts are listed in Table 7. See also Figure 3. To order parts, see How to Contact Fluke.
Table 7. Replacement Parts
Item Description
Fluke Part or
Model Number
Decal, Basic 4778372
Decal, FC 4778385
Sub Assembly, Top Case part of item 10
Keypad, Hold, Basic 4778313
Keypad, Hold, FC 4778324
D
Rubber, LCD 4778349
E
LCD Subassembly For Service 4902813
F
Rubber, PCA 4778336
G
Copper Foil, PCA, Top part of item 8
H
PCA Subassembly for Service, 1630-2 FC 4902795
PCA Subassembly for Service, 1630-2 4902808
I
Copper Foil, PCB, Bottom part of item 8
J
Jaw Subassembly, with Top Case For Service, Non-FC 4902824
Jaw Subassembly, with Top Case For Service, FC 4902836
K
Screw, M3, 13.5 mm, Pan, Phillips, Steel, Black 2388382
To Next Page
Loading...
