Need help?Do you have a question about the Fluke 125 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Safety Rating | CAT III 600 V |
| Resistance Measurement | Yes |
| Continuity | Yes |
| Diode Test | Yes |
| Harmonics Measurement | Yes |
| Power Measurement | Yes |
| Weight | 1.2 kg |
| Current Measurement | Yes |
| Type | ScopeMeter |
| Voltage Range | 600 V |
Specific warning and caution statements found throughout the manual.
Guidance on using the test tool when safety features might be compromised.
Procedure to power the test tool from an AC outlet or battery.
Procedure to restore test tool settings to factory default.
How to adjust the display brightness for power saving or visibility.
Procedure to adjust the screen contrast for optimal display readability.
Illustrates how to navigate and make selections within the test tool's menus.
Identifies the test tool's input jacks (A, B, COM) and their usage.
Safety warning regarding common connections and potential voltage differences.
How to adapt the test tool readout to the used probes and settings.
Step-by-step guide to activate the Scope/Meter mode on the test tool.
How to use Auto Set to optimize display for unknown signals.
General guidance on taking measurements using the test tool.
How to choose specific measurement functions like Frequency (Hz) or Peak-to-Peak.
Using Zero Reference to display measurements relative to a defined value.
Using smoothing functions to reduce noise in waveforms and readings.
Introduction to capturing waveform data.
Setting up the test tool to start displaying waveforms based on specific conditions.
Using cursors to make precise digital measurements on waveforms.
Using the 10:1 probe for measuring high frequency signals in high impedance circuits.
How to display and measure harmonics of voltage, current, and power.
Step-by-step guide to connect inputs and perform harmonics measurements.
Step-by-step guide to performing fieldbus measurements, selecting bus type and probes.
Explanation of the four columns displaying bus signal properties and indicators.
How to change test limits to generate OK, WARNING, and NOT OK messages.
Steps to recall, rename, or delete saved data sets from the instrument's memory.
Procedure for charging the test tool's rechargeable battery pack.
Instructions for safely replacing and disposing of the rechargeable battery pack.
Guidelines for proper grounding techniques to avoid measurement problems.
Troubleshooting common communication issues with printers and computers.
Detailed specifications for the oscilloscope function, including vertical and input characteristics.
Specifications for the dual input meter function, including accuracy and ranges.
Specifications for Ohm, Continuity, Diode, and Capacitance measurements on Input A.
Specifications for harmonics measurements, including number, readings, frequency, phase angle, and K-factor.
Table of supported Field Bus types, subtypes, and protocols.
Safety design standards and input voltage ratings for measurement categories.
To Next Page
