6-1
Chapter 6
Saving and Recalling Data Sets
Introduction
This Chapter explains how to save data sets into the test
tool’s Flash EEPROM memory and how to view, rename
and delete them.
The test tool has 20 data memories. In each memory you
can save a data set.
A data set consists of the screen data, the waveform data,
and the test tool setup.
Saving Data Sets
To save a data set do the following:
c
Open the SAVE/RECALL mode.
The screen is frozen until you
leave the SAVE/RECALL mode
again. You can leave the
SAVE/RECALL mode by pressing
the SAVE/PRINT key again.
To Next Page
Loading...
