Fluke 125 - Performing Fieldbus Measurements

Fluke 125
Users Manual
4-2
Performing Fieldbus Measurements
To perform fieldbus measurements do the following:
c Open the application mode menu.
d Highlight BUSHEALTH.
e Open the bus selection menu:
f Select the bus type.
Select User 1 or User 2 if you
want to create a customized set
of limits to test other (non
standard) bus systems. See
page 4-8 for setting the limits.
Default settings are ControlNet for
User1 and Foundation Fieldbus
H1 for User2.
g Accept your choice.
For bus types followed by 3 dots
… a new menu will open:
Use to select the
required item and press .
You will see a screen like fig 4.2.
h Select the appropriate input A and
input B test leads or probe type.
i
Connect the inputs as indicated in figure 4-1.
Use the test tool inputs as shown in table 4-1.