Fluke 125 - Plotting Measurements over Time (TrendPlot); Starting;Stopping a TrendPlot

5-1
Chapter 5
Plotting Measurements over Time (TrendPlot
TM
)
Introduction
The TrendPlot™ function plots a graph derived from the
MAIN (large) readings in the SCOPE/METER mode or in
the HARMONICS mode as a function of time.
The secondary (small) reading shows:
• the average (AVG) reading and the date and time,
or
• the minimum (MIN) or the maximum (MAX) reading
since the TrendPlot start and the date and time of the
most recent change.
Starting/Stopping a TrendPlot
TM
To start a TrendPlot™ do the following:
c Open the application mode menu.
d Highlight TRENDPLOT