Fluke 125 - Positioning the Waveform on the Screen

Scope/Meter Mode
Changing the Graphic Representation on the Screen
2
2-11
Positioning the Waveform on the Screen
Considerable flexibility is offered in moving the
waveform(s) around the screen.
c Press until you have left any open
menu. Observe that the following
main menu appears on bottom of
the screen.
d Choose A MOVE
e Position the waveform of INPUT
A on the screen.
Waveform positioning is demonstrated in Figure 2-10.
Observe that the trigger identifier (
) moves horizontally
on the screen.
Note:
For 3 phase power measurements the waveform
positions are fixed.
Figure 2-10. Positioning the Waveform