Fluke 125 - Selecting a measurement function

Fluke 125
Users Manual
2-6
Selecting a measurement function.
To choose a frequency measurement for Input A, do the
following:
c Open the A MEASUREMENTS
menu.
d Highlight Hz….
e Open the Hz-RPM submenu.
f Highlight Hz.
g Accept the Hz measurement.
Observe that Hz is now the main reading. The former main
reading has now moved to the smaller secondary reading
position. (See Figure 2-8.)
To choose also a Peak-to-Peak measurement for Input B,
do the following:
c Open the B MEASUREMENTS
menu.
d Highlight ON.
e Turn Input B on. Observe that the
highlight jumps to the present
main measurement.