Fluke 125 - Measurement Probes & Settings

Fluke 125
Users Manual
1-6
Measurement Probes & Settings
For the SCOPE/METER mode and the HARMONICS
mode various probes can be used for the test tool
measurement functions, for example a 10:1 voltage probe,
a 1mV/°C Temperature probe, or a 10 mV/A current
clamp.
To adapt the test tool readout to the used probe, do the
following:
c
(A)
(B)
The Input A or Input B
MEASUREMENTS menu and a
F1….F4 button bar pops up.
d Open the INPUT… menu.
e Highlight SELECT…
f Open the PROBE on A (B) menu
g Highlight the required probe type
h Accept the probe type. The menu
will be closed.
i
2x
Close the INPUT… menu.