Fluke 125 - Acquiring the Waveform; Making a Single Acquisition

Fluke 125
Users Manual
2-14
Acquiring the Waveform
Making a Single Acquisition
To catch single events, you can perform a single shot.
(One time screen update.) To set up the test tool for a
single shot on the input A waveform, do the following:
• Connect the probe to the signal to be measured.
c Open the application menu.
d Open the TRIGGER… submenu.
e Highlight A.
f Accept INPUT: A.
g Highlight SINGLE.
h
(2x)
Accept the Single shot setup.
The test tool will now have a screen like Figure 2-13.
Wait: appears on bottom of the screen to indicate that the
test tool is waiting for a trigger.
Run: appears on bottom of the screen when the single
acquisition is triggered.
Hold: appears on bottom of the screen when the single
acquisition has been completed.
Figure 2-13. Making a Single Acquisition
To perform a next single acquisition, do the following:
i Wait for another single acquisition
trigger.