1-1
Chapter 1
General Operating Instructions
Introduction
This Chapter provides a step-by-step introduction to the
general test tool functions.
Preparations for Use
At delivery, the batteries may be empty and must be
charged for at last 7 hours. Deeply discharged batteries
may even cause the test tool not to start up when it is
turned on. Refer to chapter 8 for charging instructions.
Powering the Test Tool
Follow the procedure (step 1 to 3) in Figure 1-1 to power
the test tool from a standard ac outlet. See Chapter 8 for
battery power instructions.
The test tool powers up in its last setup configuration.
Figure 1-1. Powering the Test Tool
Note
When battery powered, the battery indicator
informs you about the condition of the battery
from full to empty:
.
To Next Page
Loading...
