Fluke 125 - Setting the Test Limits

Fluke 125
Users Manual
4-8
Setting the Test Limits
You can change the test limits used to generate the
messages OK , WARNING , and NOT OK .
The test limits apply to the selected bus type. To change
the test limits for another bus type do steps 1-5 on page 4-
2 first.
To change the test limits, do the following:
c
From the test screen open the
SETUP LIMITS menu. You will
see a screen like Figure 4-5. The
header shows the bus type.
d Select the signal property for
which you want to set the limit.
e Select the level to be adjusted:
LOW, HIGH or ! WARNING
Press to set all limits to the
default setting.
f Change the limits.
A * in the SETUP LIMITS screen
indicates that a signal property
has limits that differ from the
default setting.
Press N/A if a limit should
not be involved in the test.
g Accept the limits and return to the
test screen.
In the test screen the text LIMIT
will be followed by a * if any of the
limits is not the default limit.
Note
Changed limits will persist until:
- you change them again,
- you reset the test tool; resetting will restore the
default limits.