Fluke 125 - Performing Harmonics Measurements

Fluke 125
Users Manual
3-2
Performing Harmonics Measurements
To perform harmonics measurements do the following:
c Connect the inputs as indicated in figure 3-1
Connect input A for VOLT and for WATT,
connect input B for AMP and for WATT.
BB120
10 mV/A - 1 mV/A
Figure 3-1. Input Connections for Harmonics
d Open the application mode menu.
e Highlight HARMONICS
f Accept your choice. You will see a
screen like figure 3-2
If input A was already set to V, and input B was already set
to AMP, the actual probe settings will be used. If not, a
PROBE menu will be shown to enable you to select the
appropriate probe setting.
To change the probe settings if the PROBE menu is not
automatically opened see Measurement Probes & Settings
in chapter 1 .