PN 2458052
October 2005, Rev. 1 9/2018
©2005, 2018 Fluke Corporation
Standard VOPs
Cable types are twisted pair unless
noted otherwise.
To set the VOP, turn on the TS100
while holding down the UP or DOWN
button. Press UP or DOWN while -VV-
is displayed; then use UP/DOWN to
adjust the value. Turn off the tester to
exit VOP adjustment mode.
See the Users Guide for instructions on
determining a cable’s actual VOP
value.
TS
®
100
Users Card
WXWarning
DO NOT USE the TS100 to test
cables that may have hazardous
voltage present. The TS100
indicates high ac voltage by
flashing 8.8.8.8. but will not detect
DC voltages.
Always handle the test clips and
cables by their insulation, NEVER by
the conductive material.
To avoid electrical shock, verify that
nothing is connected to the test
clips before removing the battery
door.
Batteries: Open the battery door on
the back of the test set by pushing the
latch toward the top. Insert the 4 AA
batteries (included), observing correct
polarity. Replace the battery door
making sure the latch snaps shut.
Line cord: Connect the line cord (test
leads) to the TS100 by inserting the
BNC connector and twisting clockwise
1/4 turn.
Note
The only line cord compatible with the
TS100 is the cord supplied with the
tester. If the wrong line cord is used,
the display shows - - - -.
VOP Cable/Wire Type
72
PIC 19 AWG
67
PIC 22 AWG
66
PIC 24 AWG (default)
64
PIC 26 AWG
67
Gel Filled19 AWG
64
Gel Filled 22 AWG
62
Gel Filled 24 AWG
60
Gel Filled 26 AWG
68
Paper 22 AWG
66
Paper 24 AWG
65
Paper 26 AWG
67
Inside Wire, CAT 5
80
Coax, RG59
81
Coax, RG6
To Next Page
Need help?
General
