Fluke 125
User Manual
9-6
Using Proper Grounding
Incorrect grounding can cause various problems. This
Section gives you guidelines for proper grounding.
z Use the short ground lead(s) when measuring DC or
AC signals on input A and input B. (See Figure 9-2.)
Warning
To avoid electrical shock or fire, use only one
COM (common) connection , or ensure that
all connections to COM are at the same
potential.
z Use the unshielded black ground lead to COM
(common) for Ohm (Ω), Continuity, Diode, and
Capacitance measurements. (See Figure 9-3.)
Using the unshielded ground lead is also possible for
single or dual input measurements for waveforms with a
frequency up to 1 MHz. This may add some hum or
noise to the waveform display due to the unshielded
ground lead.
Figure 9-2. Grounding with Short Ground Lead
Figure 9-3. Grounding with Unshielded Ground Lead
To Next Page
Loading...
