Fluke 125 - Page 70

Fluke 125
Users Manual
6-2
d Open the SAVE ... submenu.
The menu shows the default name for the data set to be
stored ‘Data n’. The n indicates the first free memory
location number. You can change the name, or save the
data set using the default name.
Continue as follows:
e Select the character you want to
change.
f Change the selected character.
The SPACE softkey replaces the
highlighted character with a space
and highlights the next character.
g When finished save the data set.
The instrument returns to normal signal acquisition again.
If no free memory locations are available message pops
up that proposes to you to overwrite the oldest data set.
Do one of the following:
c Reject the proposal to overwrite
the oldest data set, then delete
one or more memory locations,
and save again.
or
c Overwrite the oldest data set .