Energy Logger
Function Selection Buttons
21
17.
Review the logged data using the softkeys V, A, Hz, +, Power,
and Energy.
18.
To prevent unwanted operation, touch the Lock Screen target.
The default PIN to lock/unlock the screen is 1234.
See Screen Lock on page 42 f or more information.
19.
To transfer and analyze the data using the PC software, attach
the USB flash drive to the Logger and copy the logging session
and screenshot.
Note
You can also use the USB cable or the USB WiFi dongle to
transfer the measurement data.
To analyze the data using the PC software:
1.
Attach the USB flash drive to a PC with Energy Analyze installed.
2.
In the software, click Download Data and copy the logging
session and screenshot from the USB flash drive.
3.
Open the downloaded session and view the measured data.
4.
Go to the Project Manager tab and click Add Image to add the
screenshot.
For more information about how to use the Energy Analyze, see the
online help for the software.
Function Selection Buttons
The Logger has three buttons that switch between the Meter, Power,
and Logger function modes. The current mode shows in the upper left
corner of the display.
Meter
– The Meter mode is for measurement values of each phase
(A/L1, B/L2, C/L3) as:
•
Voltage (V)
•
Current (A)
•
Frequency (Hz)
•
THD of Voltage and Current (%)
•
AUX Input
You can determine the values or display a trend chart of the last
7 minutes. In the chart:
1.
Use or the cursor keys to show the list of available
parameters.
2.
Push (Reset) to clear the graph and restart.
It is also possible to log the values with the logger function.
THD of Voltage and Current show the harmonics and interharmonics
as a percentage of the fundamental.
To Next Page
Loading...
