Need help?Do you have a question about the Fluke 175 and is the answer not in the manual?
General| True RMS | Yes |
|---|---|
| Voltage DC | 1000 V |
| Voltage AC | 1000 V |
| Current DC | 10 A |
| Current AC | 10 A |
| Resistance | 50 MΩ |
| Frequency | 100 kHz |
| Continuity | Yes |
| Diode Test | Yes |
| Safety Rating | CAT III 1000 V, CAT IV 600 V |
| Weight | 420 g |
| Display | 6000 counts |
| Basic Accuracy (DC Voltage) | 0.15% + 2 |
| Basic Accuracy (AC Voltage) | ±(1.0% + 3) |
| Battery Life | Typically 200 hours without backlight |
| Dimensions | 43 x 90 x 185 mm |
| Capacitance | 10, 000 µF |
Contact information for Fluke technical support and service.
Identifies hazardous conditions and procedures for safe operation.
Lists and explains symbols used in the manual and on the product.
Alerts users to potentially hazardous voltage conditions during measurements.
Reminds users to check test lead placement for correct terminal connections.
Describes the input terminals of the multimeter and their functions.
Identifies and describes the functions of the product's buttons.
Details the different positions of the rotary switch and their corresponding functions.
Lists and explains error messages displayed by the product.
Describes the automatic power-saving feature and how to disable it.
Explains how to capture minimum, maximum, and average readings.
Details the modes for holding and automatically capturing stable readings.
Explains how to use and switch between automatic and manual ranging.
Describes special functions activated by holding buttons during power-on.
Instructions for measuring AC and DC voltage with the multimeter.
Procedure for measuring electrical resistance using the multimeter.
How to measure capacitance values using the multimeter.
Guide on performing continuity tests and interpreting results.
Steps for testing diodes and identifying forward/reverse bias.
Instructions for measuring temperature using the 179 model.
Procedure for measuring AC and DC current safely and accurately.
Explains how true-rms meters handle zero input and their accuracy.
Guide on measuring signal frequencies using the multimeter.
How to measure the frequency of AC/DC voltage signals.
Procedure for measuring the frequency of AC current signals.
Instructions for cleaning the multimeter case and terminals.
Procedure for testing the multimeter's internal fuses.
Guidance on replacing the battery and fuses safely.
To Next Page
