Fluke 301A - Basic Measurement Procedures; Hazardous Voltage Indicator; AC Voltage Measurement with Test Leads; Frequency Measurement (Hz) under AC Voltage

Clamp Meter
Maintenance
5
Safety
General ................................................................ IEC 61010-1, Pollution Degree 2
Measurement .................................................... IEC 61010-1, Pollution Degree 2
IEC 61010-2-032: CAT III 300 V
Maintenance
W Caution
To prevent possible damage to the Product or to equipment under test, do not use
abrasive cleansers.
Periodically wipe the case with a damp cloth and mild detergent. Do not use abrasives or
solvents. Dirt or moisture in the terminals can affect readings.
Battery Replacement
XW Warning
To prevent possible explosion, fire, or personal injury, replace the batteries when
the low battery indicator
( B ) shows to prevent incorrect measurements.
W Caution
To prevent possible damage to the Product or to equipment under test:
 Remove batteries to prevent battery leakage and damage to the Product if it is not
used for an extended period.
 Be sure that the battery polarity is correct to prevent battery leakage.
Figure 1 shows how to replace the battery.
Figure 1. Battery Replacement
AAA