5
Measuring
Fluke 416D
GB
D
F
I
E
P
NL
DK
NO
S
FIN
GR
TR
CZ
SK
PL
HU
RU
RO
CN
KOR
the stop bracket with a little force to the right
side; the stop bracket can now be completely
unfolded. See drawing {E}.
CAUTION:
Make sure that when measuring from the
unfolded endpiece, the measuring reference point is
set to "End piece".
1x briefly: the next measurement is taken from
the front edge.
2x briefly: the measurement is taken from the
unfolded end piece.
After one measurement, the reference point returns
automatically to the default setting (rear reference
point).
1x long: the measurements are taken with the
front as reference until a new measuring refer-
ence point is set.
2x long: the measurements are taken from the
unfolded end piece until a new measuring refer-
ence point is set.
See drawing {F}.
Measuring
Single Distance Measurement
1x briefly: the laser is activated.
1x briefly: a distance measurement is taken.
The result is displayed immediately.
Continuous measurement
Distances can be measured with this function.
1x long: a "beep" is emitted. A continuous
measurement is started.
1x briefly: the continuous measurement is
stopped.
The last measured value is displayed in the primary
display.
Minimum-/Maximum-Measuring
This function enables determining the minimum or
maximum distance from a specific measuring point,
e.g. the determination of room diagonals (maximum
value) or horizontal distance (minimum value).
Switching on continuous measurement (see above).
The corresponding maximum and minimum values are
displayed.
To Next Page
Loading...
Need help?
General
