5730A
Getting Started Manual
2
• An auxiliary current binding post to calibrate meters with separate current inputs
without the need to move cables.
• Real-time clock and calendar for date stamping reports and reminders issued to
perform the dc zeros calibration procedure within the required interval.
• Offset and scaling modes that simplify linearity tests of multimeters.
• Variable phase reference signal output and phase-lock input.
• Interface for the Fluke Calibration 5725A Amplifier.
• Interface for the Fluke Calibration 52120A Amplifier.
• Standard IEEE-488 (GPIB) interface, that complies with ANSI/IEEE Standards
488.1-1987 and 488.2-1987.
• EIA/TIA-574 Standard RS-232 serial data interface for remote control of the
Calibrator.
• Universal Serial Bus (USB) 2.0 high-speed interface device port for remote control of
the Calibrator.
• Integrated 10/100/1000BASE-T Ethernet port for network connection remote control
of the Calibrator.
• Extensive internal self-testing and diagnostics of analog and digital functions
• USB Host port to save calibration reports to a flash drive.
• Visual Connection Management output terminals illuminate to help show correct
cable connection configurations.
• Soft Power - automatic selection of line voltage/frequency.
• LCD Color VGA display with touch panel overlay.
• A traceable calibration procedure for all modes and ranges that requires only 10 V,
1 Ω, and 10 kΩ external standards, with only occasional independent verification.
• Automated calibration check that provides added confidence between calibration
recalls, and data that can be used to document and characterize Calibrator
performance between calibration recalls.
To Next Page
Loading...
Need help?
General
