53
Calibration Procedure
Calibration Procedure
“R0” is displayed.
Press “SET” then use the “UP” or “DOWN” keys until the correct nu merical 2.
setting is displayed. Press “SET” to accept the new value.
Repeat step 2 for ALPHA and DELTA. 3.
Accuracy & Repeatability 12.2.3
Check the accuracy of the Micro-Bath at various points over the calibrated range.
If Micro-Bath does not pass specification at all set-points, repeat the Calibration
Procedure.
1.888.475.5235info@Fluke-Direct.com
Fluke-Direct.com
To Next Page
Loading...
