CableMeter
Getting Acquainted
3
•
Never operate portable transmitting
devices during a cable test. Doing so
might cause erroneous test results.
Getting Acquainted
Display, Switches, and Connections
LAN CABLEMETER
620
SETUP
ENTER
1
4
5
2
3
abm01f.eps
Figure 1. Cable Meter System
Table 2. Features
ITEM FUNCTION
A
LCD
A 2-line by 16-character LCD display. When there is
more information than can be displayed on two lines,
and up arrow, down arrow, or bidirectional arrow
appears in the left side of the display. Press the
corresponding C or D key to display the
additional information.
B
E
Enters a selection into the test tool and moves to the
next setup selection. Causes current cable selection to
be displayed and a new measurement cycle initiated
when not in Setup Mode.
C
B
Turns the display backlight on or off. Backlighting turns
off automatically after 70 seconds.
D D C
Scrolls through a selection of choices or multiple
displays
E
A
Provides access to cable selection, calibration, and
other test tool settings.
To Next Page
Loading...
