Fluke 620 - Setup Selections

CableMeter
Setup Selections
19
Setup Selections
The setup mode allows you to select cable characteristics
and customize the test tool’s operation. Once changed,
these settings are stored and remain in the test tool even
when it is turned off. Setup selections that rarely need
changing are under a special “Power-up” menu.
Setup allows you to:
Select cable type (UTP, STP, FTP, or COAX)
Select a wiring standard
Select a cable category
Select a wire size
Calibrate the test too to a specific cable
Enable or display the Beeper for PASS and FAIL
Adjust the display contrast
* Select the display language
* Select length measurement units between feet (‘)
and meters (m)
* Select wire size units between AWG and
millimeters (mm)
* Set the noise filter for 50 Hz or 60 Hz
* “Power-up” setup selections.
To make a SETUP selection, do the following”
1. Press A.
2. Press A to step through the selections.
3. Press C or D to select the desired setup
condition.
4. Press A to exit the setup mode, or press E to
move to the next setup selection.
To make a “Power-up” setup selection, do the follwoing:
1. With the test tool OFF, press and hold A while
turning the rotary switch to TEST.
2. Press E to step through the selections.
3. Press C or D to select the desired setup
condition.
4. Press A to exit the setup mode, or press E to
move to the next setup selection.