716 English Instruction Sheet
Page
1
®
716
Pressure Calibrator
Instruction Sheet
Introduction
The Fluke Model 716 Pressure Calibrator (hereafter called
“Calibrator”) calibrates P/I (pressure to current) transmitters,
measures pressure via a Fluke 700 Series Pressure Module,
measures current up to 24 mA, and supplies loop voltage. The
Calibrator simultaneously displays pressure and current
measurements.
The Calibrator makes 5-digit pressure readings in the following
units: psi, inH
2
O at 4 °C, inH
2
O at 20 °C, kPa, cmH
2
O at 4 °C,
cmH
2
O at 20 °C, bar, mbar, kg/cm
2
, inHg, and mmHg. Full scale
readings for all pressure ranges can be made in psi, kPa, and
inHg units. To avoid display overflow, full scale readings are
limited to 1000 psi in cmH
2
O, mbar, and mmHg units and
3000 psi in inH
2
O units. Pressures of at least 15 psi must be
measured for meaningful readings in bar and kg/cm
2
units.
Your Calibrator is supplied with a Flex-Stand holster, an
installed 9 V alkaline battery, one set of TL75 test leads, one set
of AC70A alligator clips, and this instruction sheet.
If the Calibrator is damaged or something is missing, contact the
place of purchase immediately. Contact your Fluke distributor for
information about accessories. See “How to Contact Fluke.” To
order replacement parts or spares, see “Replacement Parts.”
PN 690008 March 1998
1998 Fluke Corporation. All rights reserved. Printed in U.S.A.
All product names are trademarks of their respective companies.
To Next Page
Need help?
General
