Pressure Calibrator
Remote Operation
49
Units Meaning
PCT_ERR Percent Error
PERCENT Percent
PT385_100 100 Ohm 385 Platinum RTD type
PT392_100 100 Ohm 392 Platinum RTD type
PTJIS_100 100 Ohm JIS Platinum RTD type
P1 P1 pressure measurement function
RTD Temperature measure function
ST_P1 Switchtest mode with P1
ST_EXT Switchtest mode with external module
SOURCE Source state
SIM Simulate state
UPPER Designates Upper display
V Voltage
Table 8. Error Codes
Error Number Error Description
100
A non-numeric entry was received
where it should be a numeric entry
101 Too many digits entered
102
Invalid units or parameter value
received
103
Entry is above the upper limit of the
allowable range
104
Entry is below the lower limit of the
allowable range
105
A required command parameter was
missing
106
An invalid command parameter was
received
107 Pressure not selected
To Next Page
Loading...
