Fluke 719PRO - Page 58

719PRO
Users Manual
48
Command Description
SIM?
Returns the value of the current being
simulated.
ST_CLOSE?
Returns pressure value at which the
switch closed
ST_DEAD?
Returns pressure value of the
deadband of the switch
ST_OPEN?
Returns pressure value at which the
switch opened
ST_START Starts a switch test
TEMP_UNIT
Set the RTD to read in °F or °C on the
indicated display
TEMP_UNIT? Returns the unit the RTD is set to
VAL? Returns the measured values
ZERO_MEAS Zeros the pressure module
ZERO_MEAS?
Returns the zero offset of the
pressure module
Table 7. Parameter Units
Units Meaning
CEL Temperature in degrees Celsius
CUSTOM Custom RTD type
DCI Current function
DCV Voltage measure function
EXT
External pressure measurement
function
FAR Temperature in degrees Fahrenheit
LOWER Designates Lower display
MA Milliamps of current
MEASURE Measure state
MEAS_LOOP Measure with loop power state
MIDDLE Designates Middle display
OHM Resistance in ohms