Fluke 719PRO - Page 57

Pressure Calibrator
Remote Operation
47
Command Description
LOCAL
Returns user to manual operation of
the Product
LOCKOUT
Locks out the keypad of the Product in
remote operation
LO_ERR
Sets the 0 % of span limit for percent
error mode
LO_ERR
Returns the 0 % of span limit for
percent error mode
MOTOR_ON Turns the motor on.
MOTOR_OFF Turns the motor off.
MOTOR?
Returns the current state of the Hart
resistor
OHMS?
Returns ohms value measured from
the RTD
OUT
Set the Product to output the
requested current.
OUT?
Returns the value of the current being
simulated.
Command Description
PRES_UNIT
Set the pressure unit for the indicated
display
PRES_UNIT?
Returns the pressure from the
indicated display
PUMP_LIMIT
Sets the approximate value at which
the pump will turn off.
PUMP_LIMIT?
Returns the approximate value at
which the pump will turn off.
REMOTE Puts the Product in remote mode
RTD_TYPE Sets the RTD type
RTD_TYPE? Returns the RTD type
SIM
Set the Product to simulate the
requested current.