Fluke 732a - Page 67

732A
Section
6
Accessories
6-1. INTRODUCTION
6-2.
This
section of the
manualdescribes
the accessories
available
for
use
with the model 732A.
6-3.
DUAL
MOUNTING
FASTENER
(MOO-800-523)
6-4.
The
Dual
Mounting
Fastener is
a
8-32
threaded
fastener
designed
for
bolting
two half-rack width
instruments
together.
The Dual
Mounting Fasteners may
be
used
for
either dual rack
mounting applications
(as
used in
the M07-200-603
Full-Width Rack Mount Kit) or
dual
table
top
applications.
Four
MOO-800-523
fasteners
are
required
for
each
pair of
half-rack width instruments.
6-5.
HALF-WIDTH
RACK
MOUNT
KIT
(M07-203-601)
6-6.
The
Half-Width
Rack
Mounting
kit permits the
732A to
be
rack
mounted. A blank
filler panel is supplied,
allowing
left
or
right
hand
offset mounting. Assembly
instructions
are supplied
with the kit.
6-7.
FULL-WIDTH
RACK
MOUNT
KIT
(M07-200-603)
6-8.
The
Full
Width
Rack
Mounting
kit
permits the
732A
to
be
rack
mounted
side-by-side
with another half
rack
width
instrument.
This rack
mounting
method
requires
the 732A
to be
bolted
to
the adjacent
instrument.
To
facilitate
bolting
the
instruments
together,
four MOO-
800-523,
Dual
Mounting
Fasteners
are included with
the
kit.
Assembly
instructions are supplied
with
the kit.
6-9.
LOW
THERMAL EMF CABLE ASSEMBLY
(5440A-7002)
6-10.
The
Low
Thermal EMF Cable Assembly
minimizes
the
effects
of
thermal emf errors
in
test
and
calibration
set-ups.
The plugs
used are made
of the same
material
as
the
jacks used
in
the
instrument. Connections
between
the
cables and plugs
are
carefully made to
minimize
generation of
thermal
errors.
6-11. BATTERY
PACK
(732A-7001)
6-12.
The Battery
Pack is a
replacement
module
for the
rear
panel.
Battery
Module
on
the 732A. It may
be
used as
an
additional
auxiliary
source, or as a spare.
6-13.
TRANSIT
CASE
(732A-7002)
6-14
The
Transit
Case
provides a means of
transporting
the
732A
while
continuously
powered by
a
battery source
contained
within
the
Transit Case. This
allows
continuity
of
standardization
transportation
over
long distances.
6-15.
BATTERY
CHARGER
(732A-7003)
6-16.
The
Battery
Charger
provides the
capability
to
charge
up
to
four
battery
packs at once.
This
unit
is
designed
to
be
used
with the
transit
case
for
extended
battery
operation
during
transit.
6
-
1 /
6-2