Fluke 754 - Supported Vs. Generic Transmitters

754
Users Guide
6
Supported vs. Generic Transmitters
The Product communicates with most HART transmitters. “Supported Transmitters” are transmitters in which the Product is
programmed to use their device-dependent commands and software version. “Generic transmitters” are transmitters that are
not programmed in the Product. Table 1 shows the operations that are available for supported vs. generic transmitters in
single-point and multidrop configurations.
Table 1. Supported vs. Generic Transmitters (Devices)
Supported Transmitter Generic Transmitter
Menu Operation
Single Point Multidrop Single Point Multidrop
Top Level Active Device screen • • • •
Basic (read/write, cloning capability) • • • •
Sensor • •
Read only Read only
(Temperature) Sensor (read/write) • •
Device Identification (read/write) • • • •
HART Output (read/write) • • • •
Setup
HART Information (read only)
• • • •
Loop Test • Not Available • Not Available
Pressure Zero Trim • • • •
Output Trim • Not Available • Not Available
Service
Sensor Trim
• • Not Available Not Available
Process Detailed process information • • • •