HART Mode
Communication Operations
7
Note
Sensor trim is supplied for supported
transmitters, with some exceptions, as identified
in the list of supported transmitters that you can
see on the display.
1. To show a list of supported transmitters and software
versions:
• If the Product is connected to a HART
transmitter, push the Abort softkey, and then
More Choices. Continue to Step 2.
• If the Product is not connected to a HART
transmitter, push r and then More Choices.
Continue to Step 2.
2. Push the Device Revs softkey. The screen in Figure
4 is shown.
gnx07s.bmp
Figure 4. Supported Device Screen
3. Push or to highlight the applicable
manufacturer, and push . A list of model
numbers is shown.
4. Push or to highlight the model number, and
push . A list of software versions is shown.
Communication Operations
Figure 5 shows the HART Mode menu tree. Menu
selections are determined by the type of transmitter that
you use and the configuration connection type (current
loop or multidrop).
To Next Page
Loading...
