Fluke 754 - Maintenance; Battery Replacement; How to Clean the Product

Documenting Process Calibrator
Maintenance
35
Maintenance
XWWarning
To prevent possible electrical shock, fire, or personal injury:
• Have an approved technician repair the Product.
• Do not operate the Product with covers removed or the case open.
Hazardous voltage exposure is possible.
• Remove the input signals before you clean the Product.
• Use only specified replacement parts.
Battery Replacement
Replace the battery when it no longer holds a charge for the rated interval. The battery
normally lasts for up to 300 charge/discharge cycles. To order a replacement battery, see
“Contacting Fluke” and “Replaceable Parts”.
Note
Spent batteries should be disposed of by a qualified recycler or hazardous
materials handler. Contact an authorized Fluke Service Center for
recycling information.
How to Clean the Product
Clean the Product and pressure modules with a soft cloth dampened with water or water
and mild soap.
WCaution
To prevent possible damage to the Product, do not use
solvents or abrasive cleansers.