Fluke 80i-1010 - Cleaning and Storage

1. Set the voltmeter range to accommodate a reading of 200 mV ac.
2. Setthe calibrator and amplifier controls to source 1A at 50 or 60 Hz
ac inthe 50-turn coil, thus producing 50A turns. The voltmeter should
display a reading between 48.2 and 51.8 mV.
3. Setthe calibrator and amplifier controls to source 2A at 400 Hz ac in
the 50-turn coil, thus producing 100A turns. The voltmeter should
display a reading between 97.0 and 103.0 mV ac.
4. Set the voltmeter range to accommodate a display of 1.000V ac.
5. Setthe calibrator and amplifier controls to source 10A at 50 or 60 Hz
ac in the 50-turn coil, thus producing 500A turns. The voltmeter
should display a reading between 488.0 and 512.0 mV ac.
6. Set the amplifier to standby.
7. Remove the probe from the 50-turn coil. This completes the AC
Operation verification procedure.
CLEANING AND STORAGE
Clean the mating surfaces of the core at regular intervals. Apply a light
coating of dripless oil to prevent corrosion. If the probe will not be used
for periods of longer than 60 days, the batteries should be removed and
stored separately.