Fluke 825A - Warranty

WARRANTY
The
JOHN
FLUKE
MFG,
CO.,
INC.
warrants
each
instrument
manufactured
by
them
to
be
free
from
defects
in
material
and
workmanship.
Their
obligation
under
this
Warranty
is
limited
to
servicing
or
adjusting
an
instrument
returned
to
the
factory
for
that
purpose,
and
to
making
good
at
the
factory
any
part
or
parts
thereof;
except
tubes,
fuses,
choppers
and
batteries,
which
shall,
within
one
year
after
making
de-
livery
to
the
‘original
purchaser,
be
returned
by
the
original
purchaser
with
transpor-
tation
charges
prepaid,
and
which
upon
their
examination
shall
disclose
to
their
satis-
faction
to
have
been
thus
defective.
If
the
fault
has
been
caused
by
misuse
or
abnormal
conditions
of
operation,
repairs
will
be
billed
at
a
nominal
cost.
In
this
case,
an
estimate
will
be
submitted
before
work
is
started,
if
requested.
If any fault develops, the following steps should be taken.
1. Notify the John Fluke Mfg. Co., Inc., giving full details of the difficulty,
and
include
the
Model
number,
type
number,
and
serial
number.
On
receipt
of
this
information,
service
data
or
shipping
instructions
will
be forwarded to you.
2.
On
receipt
of
the
shipping
instructions,
forward
the
instrument
prepaid,
and
repairs
will
be
made
at
the
factory.
If
requested,
an
estimate
of
the
charges
will
be
made
before
the
work
begins,
provided
the
instrument
is not covered
by the Warranty.
SHIPPING
All
shipments
of
John
Fluke
Mfg.
Co.,
Inc.
instruments
should
be
made
via
Railway
Express
prepaid.
The
instrument
should
be
shipped
in
the
original
packing
carton;
or
if
it
is
not
available,
use
any
suitable
container
that
is
rigid.
If
a
substitute
con-
tainer
is
used,
the
instrument
should
be
wrapped
in
paper
and
surrounded
with
at
least
four inches of excelsior
or similar
shock-absorbing
material.
CLAIM FOR DAMAGE IN SHIPMENT
The instrument should be thoroughly inspected immediately upon receipt. All material
in
the
container
should
be
checked
against
the
enclosed
packing
list.
Тһе
manufac-
turer will not be responsible for shortages against the packing sheet unless notified
immediately.
If
the
instrument
fails
to
operate
properly,
or
is
damaged
in
any
way,
а claim should be filed with the carrier. А full report of the damage should be ob-
tained by the claim agent, and this report should be forwarded to John Fluke Mfg.
Co., Inc. Upon receipt of this report you will be advised of the disposition of the
equipment for repair or replacement. Include the model number, type number, and
serial number when referring to this instrument for any reason.
The John Fluke Mfg. Co., Inc. will be happy to answer all application questions which
will enhance your use of this instrument. Please address your requests to:
JOHN FLUKE MFG, CO., INC., Р.О. BOX 7428, SEATTLE 33, WASHINGTON
У