Fluke 8502A - Storing and Displaying Limits; Peak Value Recording and Recall

DISPLAY INDICATIONS WHEN PROGRAMMING THE
8S02A
The display
will respond to memory
programming as in the following
example:
PRESS
DISPLAY RESPONDS
STORE
"7"
NUMERIC
YES?
OFFSET
Go
(numbers) 1, 2,
3 . . .
ENTER
Return to
normal display.
LIMITS
1. Select ttie
Limit
mode by
depressing the
LIMIT switch. A display
of HI,
LO,
or PASS will
indicate that the mode
has been entered.
Depress LIMIT
a
second time to
exit
the mode.
2. To store any displayed
value as a limit value; use the
following
sequence:
STORE
—
HI
STORE LO
The value t^ing
entered will be displayed as
long
as
HI or LO are held
depressed. Release
of
eiliier
switch will enter the value as the
respective limit.
LIMIT must
be
separately depressed
before or
after
entering
values
to
enter
the
Limit mode.
3.
To enter
numeric values as limit values,
press:
HI
STORE
—
NUMERIC
or (value numbers)
—
ENTER
LO
LIMIT must be depressed to enter the mode.
4. To
display the
stored limits, press:
HI
RECALL-* or -*LIMIT
LO
The respective value vviil
be
displayed as long as
LIMIT is held
depressed.
PEAK
1.
Press PEAK to toggle into or out
of the Peak mode
(PEAK LED will come on).
2. To
display the
readings
recorded
in this mode, use the
following sequence:
HI
RECALL
—
* or
—
* PEAK
LO