Fluke 8502A - Page 27

8502A
STORE
Use the numeric sequence
whenever entering
a
value
(as
in Offset) or a
particular
mode {as
in Filter) into
the
8502A's memory. Use the following procedural
steps;
1. Initiate the numeric entry.
Press:
STORE
appears in display)
NUMERIC (YES? appears in
display)
2.
Select the desired use for
the
numeric entry.
Press:
OFFSET (Go appears in
display)
(SCALING FILTER,
SAMPLE,
HI or LO
for LIMITS).
3.
Select the desired numbers. Numbers will appear
in
the
display from left to right as they are entered.
NOTE: Press CE if an
error is
made
during
the
following number, polarity and exponent entry steps. The
8502A will then display Go. Start entries
again from this point.
-
a.
For Filter, enter the
mode
number
(—,
0,
1,2,
or
3).
b.
For Sample, enter the exponent
of
2
for samples averaged in each reading (0 through 17).
c.
For Offset,
enter the number(s)
for
the
offset factor.
d.
For Scaling, enter the number(s) for the scaling factor.
e.
For Limits (HI, LO), enter the
numeric
values
desired.
4.
To
change the polarity of the numeric entry, press:
+/-
5. To add an
exponent to
die
numeric entry, press:
EXP
6. To change
polarity for
the
exponent, now press:
+/-
7. To
finalize
storing of the
entry
and
exit
the
numeric sequence, press:
ENTER
8.
The value is now stored. For Filter or Sample entries, the value is now
also
in
effect.
For Offset,
Scaling or Limits,
the value will not
become effective until
the appropriate
mode is selected.
Figure
2-7.
Numerics (cont)
2-17