Fluke 8808A - Options and Accessories; Factory Settings of RS-232 Communication Parameters

Digital Multimeter
Options and Accessories
11
4. Press U or V to scroll to desired data bits (7 or 8) selection, then press
R for 2 seconds to set parity. Echo appears on the secondary display, and 0n
or 0FF appears on the primary display.
5. To select an Echo mode, press U or V to select On or OFF, and then press
R for 2 seconds to set the selected Echo state. When Echo is on, each
command sent to the Meter over the RS-232 interface is echoed to the host's
display screen. When Echo is off, commands are not echoed.
6. Press R to review the settings. When you are ready to accept the settings,
press and hold R for 2 seconds.
Table 5. Factory Settings of RS-232 Communication Parameters
Parameter Factory Setting
Interface RS-232 (Print-only rate set to 0)
Baud rate 9600
Parity None (parity bit 0)
Number of data bits 8 (7 data bits plus 1 parity bit)
Number of stop bits 1
Echo On
Options and Accessories
Table 6 lists available options and accessories.
Table 6. Accessories
Item Model / Part Number
Premium Test Lead Set TL71
Fuse, .25*1.25, 0.063 A, 250 V, Slow 163030
Fuse, .25*1.25, 0.125 A, 250 V, Slow 166488
F1 - Fuse, 11 A, 1000 V, Fast, 406INX1.5IN, BULK 803293
F2 - Fuse, 440 mA, 1000 V, Fast, 406INX1.375IN, BULK 943121
Rack Mount Kit 8845A & 8846A Single Y8846S
Rack Mount Kit 8845A & 8846A Dual Y8846D
RS-232 Cable (2 m) RS43
Precision Electronic Prob Set TL910
2X4 Wire Ohms 1000 V Test Lead TL2X4W-PTII
FlukeView Forms Basic Software FVF-SC5
FlukeView Forms Software Upgrade to enhanced version FVF-UG